Rotted board repair
Damaged fascia is replaced with primed wood or PVC so gutters have solid backing.
Exterior Services
Fascia Repair Montvale, NJ
A roofing contractor in Montvale can fix soft, split or loose fascia along the roof edge, whether it is painted wood, PVC or wrapped in aluminum, and check the rafter tails behind the board while it is off. Dial (551) 390-0362 to talk with a local roofer about the fascia.
When a fascia board goes soft, the cause is almost always water running down the back of the gutter instead of into it. Without a drip edge lapped into the gutter, runoff clings to the roof edge and wets the top of the fascia every storm. The wood slowly loses strength until the gutter spikes or hanger screws no longer hold.
Rotted fascia is often the visible part of a bigger problem. Left alone, the rot moves into the rafter ends and the edge of the roof deck, which turns a trim repair into structural work. Aluminum wrap over wood can hide all of this, since the metal looks fine while the board behind it crumbles.
Before the visit, take a look along the roof edge from the ground. Look for sections where the gutter tips forward, where the board looks dark or swollen and where paint is flaking. Say whether the fascia is bare wood, painted, PVC or wrapped in metal, since that changes the repair.
If the problem goes deeper than it first looked, a Montvale roofer may also recommend soffit repair or gutter installation.
Dealing with this in Montvale, NJ right now? Call (551) 390-0362 to reach a nearby roofing contractor.
Call nowThe process
How fascia repair works
A fascia repair only lasts if the water that rotted it is redirected.
Check the edge
The roofer checks the drip edge, the first course of shingles, the gutter pitch and the downspouts above the damaged fascia. The length of the damage decides how much board is replaced.
Free the board
To reach the fascia, the gutter over it is removed and the hangers pulled. Worn spikes are replaced with hidden hangers and screws.
Inspect behind the board
Soft rafter tails are cut back and sistered with new lumber, and rotted decking at the edge is replaced. Skipping it is the most common reason fascia fails twice.
Install new fascia
A replacement board matched to the existing size goes up, sealed at the ends and joints. PVC and composite boards do not rot and hold paint well.
Fix the edge flashing
Drip edge flashing is slid under the shingles and over the gutter back, so water cannot reach the wood. It is a small part that does most of the work.
Reattach gutters
Gutters are rehung on the new fascia with a slight slope toward the outlets. Wood fascia gets a finish coat of paint.
What is included
Fascia repairs a roofer can handle
Gutter reattachment
Sagging gutters are rehung on solid fascia with new hangers so they drain instead of overflowing.
Aluminum wrap
Coil stock wrap is bent to fit over solid boards with the drip edge lapped over it.
Framing repair
Rotted rafter ends behind the fascia are sistered or rebuilt so the new board stays put.
Edge flashing
New drip edge is tucked under the shingles over the gutter which stops the rot from coming back.
Related service
Fascia Board Replacement Montvale, NJ
Full fascia board replacement is the right call when soft spots keep turning up along the same edge or when old boards are cracked throughout. With the old fascia off, every rafter end can be checked and repaired before the new boards are fastened. Many homeowners switch to PVC or composite fascia at this point because it will not rot.
In Montvale, fascia board replacement often lines up with a new roof or new gutters, since the roof edge is already being worked on. Be wary of any plan that covers rotted boards with metal instead of replacing them. Also ask about the size of the new boards, since fascia that is too narrow can leave gaps at the soffit and gutter.
Related service
Fascia Board Repair Montvale, NJ
When rot is confined to short stretches, the damaged part of the board can be cut out and a new piece scarfed in. A scarf joint, cut at an angle and glued and fastened, blends the new piece into the old board and sheds water better than a square butt joint. Minor surface damage may only need consolidant, filler and paint.
A fascia board repair in Montvale should always include a look at why that spot got wet. That usually means resealing a gutter seam, unclogging a downspout or adding drip edge over the repaired section. Once the wood is primed and painted on all sides, a repaired section can last as long as the rest of the board.
Local help
Fascia Repair Near Me
Fascia repair calls in Montvale come from older homes with painted wood trim and newer homes with aluminum-wrapped edges alike. Homes in Montvale and nearby towns like Park Ridge, Woodcliff Lake, Saddle River and Hillsdale range from older houses with wood fascia that needs regular paint to newer builds where metal wrap can hide rot underneath, so a look along the roof edge each spring and fall helps catch soft spots early.
For fascia repair in Montvale, NJ or nearby towns like Park Ridge, Woodcliff Lake, Saddle River and Hillsdale, call (551) 390-0362 to reach a roofer who covers your street.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Montvale, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why fix it now
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Roofers in Montvale know the roof types and weather wear common in local homes.
Straight answers
Ask your questions before you agree to anything.
Fascia Repair FAQ
Should I cover rotted fascia with metal?
Metal wrap only belongs over sound wood. The gutter hangers still screw into the wood behind the wrap, so they loosen as the board softens. Fix the wood, then add wrap over it.
What causes fascia boards to rot?
Fascia rots when water runs down the board instead of into the gutter. A missing drip edge, clogged gutters and leaking gutter seams all keep the wood wet after every rain. Peeling paint and unsealed cut ends speed up the damage.
Can fascia be repaired instead of replaced?
Repair is fine when damage is limited to a few spots and the rafter tails are sound. Long stretches of soft wood are better handled by replacing the whole board. The framing behind the fascia decides how big the job really is.
Why do gutters pull away from the fascia?
Gutters hang from the fascia, so their strength depends on it. When the wood softens, hanger screws and spikes lose grip and the gutter sags, tips forward or pulls away. The fix is solid wood plus new hangers, pitched toward the downspout.
Which fascia material lasts longest?
PVC and composite fascia resist rot and hold paint well. Wood is common on older homes and works well when kept painted. No material holds up if water keeps running behind the gutter.
More questions? Call (551) 390-0362
Often needed together
Soffit Repair
Fixing damaged soffits, blocked soffit vents and gaps where animals get in, matched to what is causing the damage in the first place.
Learn moreGutter Installation
Seamless gutter installation sized to the roof, pitched to the downspouts and hung on hidden hangers, with the fascia checked before anything is hung.
Learn moreGutter Repair
Fixing gutters that drip at the corners, sag between hangers or pull away from the fascia, before the leaks rot the fascia behind them.
Learn moreRoof Repair
Targeted roof repairs for wind, age and water damage, so a sound roof keeps working for years.
Learn more
Looking for something else?
See all roofing servicesGet fascia repair help in Montvale
Call (551) 390-0362 to talk to a roofer serving Montvale, NJ.